Motorcycle Frames - Rigid

Filter

    Filter

    Brand

    Collection

    clear
    Motorcycle Frames - Rigid from K and G Cycles!
    2 products

    2 products

    V-Twin Manufacturing Replica Frame Hardtail
    V-Twin Manufacturing
    $687.43
    V-Twin Manufacturing Weld on Motorcycle Hardtail Raw Finish
    V-Twin Manufacturing
    $337.74
    V-Twin Manufacturing Replica Frame Hardtail Harley V-Twin Manufacturing - K and G Cycles
    V-Twin Manufacturing

    V-Twin Manufacturing Replica Frame Hardtail

    VT-51-0457

    $687.43

    In Stock

    Save $-687.43
    /
    Shipping calculated at checkout.

    Replica rear hardtail frame section is duplicated from an original rigid frame. Weld-on type and does not have seat post bushing.
    The rear transmission mounts are 1-1/2" tall. This hardtail includes rear transmission mount, tool box bracket, fender cross brace, seat post top yoke, and 2 dowel pins to connect lower frame tubes. Installer must weld lower tube inserts and top seat post yoke assembly in place, which requires alignment and fitting of the components. Top seat post forging is included but not welded in place, fabricator or installer must add tubing and seat post bushing. *NOTE: The seat post bushing must be ordered separately. *NOTE: Transmission height shimming may be required. The axle slots are 7/8" on both sides.
    Replica rear hardtail frame section is duplicated from an original rigid frame. Weld-on type. This hardtail includes rear transmission mount, tool box bracket, fender cross brace, seat post top yoke, and 2 dowel pins

    FX 1971-1984
    FL 1958-1984

    Tubing O.D.: 1" Wall Thickness: .17"
    V-Twin Manufacturing Weld on Motorcycle Hardtail Raw Finish Harley V-Twin Manufacturing - K and G Cycles
    V-Twin Manufacturing

    V-Twin Manufacturing Weld on Motorcycle Hardtail Raw Finish

    VT-51-0786

    $337.74

    In Stock

    Save $-337.74
    /
    Shipping calculated at checkout.

    FXD raw weld on hardtail is easy to install as the alignment is accomplished in the mount design provided.
    Raw weld on hardtail uses a 14-1/2" rear axle, a chrome rear caliper kit and a battery box is recommended when building this hardtail. Welding should be performed by a skilled welder technician. Custom application on 1991-1998 FXD and FXDWG models.
    Raw weld on hardtail is easy to install as the alignment is accomplished in the mount design provided. Raw weld on hardtail uses a 14-1/2" rear axle, a chrome rear caliper kit and a battery box is rec

    FXD 1990-1998
    FXDWG 1990-1998

    Between Axle Plates: 11-3/8"